Cautions

Thermaltake recommends the following steps to be taken after completing your water loop setup

• It is strongly recommended to use market-proven pre-mixed coolant, such as Thermaltake Coolant 1000, which offers great performance while preventing corrosion in the entire cooling system (copper, brass, nickel, aluminum, and steel).
• Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
• DO NOT let the pump run dry. If no liquid is entering the pump, turn off the power immediately.
• Fill the reservoir to the top to prevent air from entering the pump.
• If necessary, tilt the system slightly from side to side to bleed the air out of the loop.
• Place paper towels under fittings and joining points to test for leaks.
• Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
• Before starting, flush out the system properly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
• Coolant might fade over time

Specification

Part Number (P/N):
CL-W434-PL16TR-A

Color:
Transparent

Tubing Specifications

Inner Diameter (ID):
12 mm

Outer Diameter (OD):
16 mm

Length:
500 mm x 4 Pieces

Material

Material Type:
PCTG